Work on a farm in Denmark 2021 episode 159b ... harvesting wheat Hello! Captain's log Work on a farm in Denmark episode 159 Welcome to the second part of "Work on a farm in Denmark" episode 159 we have a change of plans and we are going to harvest wheat Henning is not available and I have to, this one ... operate the harvester today I have to be careful, because here I have a million PLN behind the wheel it is not that simple it is not Farming Simulator We drive 3.3 km / h and I want to show you how Power ..., Power Flow belts receive how they receive ... wheat what is it ... What is a good solution
Jens drives Jens drives ... with a trailer I don't know if you will believe it, but it shows me now 12 t / ha, this is the field we started harvest recently and since then it has been raining all the time I'll show you see how much it is currently it gives 10.5 t / ha is given by the computer and in a moment I will show you a place 12 t / ha 11 t / ha now shows 3.2 per hour (km / h) I'm going, you will not go faster, you will lose more with straw in the back the slower we go then the sieves have more time when you reach the end, look, I did not even leave this ... reel, the belts swallowed all the wheat
when you get to the end, you should give a few seconds for the straw to fall out so that this colleague who will collect straw with a press/baler so that at the end he does not have to do these twigs, give these 5 seconds extra when every trip it will not save you so that ... well, it would be nice to have the straw lying nicely, unless you chopp straw, well, many people have to give this reel sharp at once , because e.g. a scythe is dull, I know that such situations are, because I was doing Bison and Vistula harvesters, I was driving and there are such situations that you have to push this reel I know about it, but I'm talking about new harvesters Jens drives in the tractor is my boss now you can see him if you want to see my boss, now on the camera, he is in the tractor , but where is Henning? this is a good question , I will tell you: Jens was farm practicing in Australia in the begining of 1980s and I will talk to him, if he will allows me scan the pictures of the tractors he used in the 1980s in Australia , he was probably on the farm practice for half a year . .. Western Australia, Perth Empty! here I have a second Puma in case Jens did not have time to return with the unloading, because he drives and unloads the floor that you have seen in the movies on our floor to dry, that is, he drivess, 2 km to the base he drops the load and returns and he must do it before I have a full tank but one more unloadimg will be 11.0 11.1 (t / ha) on average we have 10.4 tons per hectare here, but there was a moment that it was 12 (t / ha) but my battery was discharged :( but these times will come back in the tank it's already the weekend and my brother Jarek visited me in the field today again because he is always in Copenhagen on weekends, he will drive to GS (Gmina Spółdzielnia) now we have ... 11,9 tony
... there are 12 tons 11.8 we have ... a joystick with a throttle, i.e. frorward and rverse on the hydrostat very sensitive here is the header up-down or automatic lowering press once and it drops to the programmed height reel up-down and reel: extend and retract retracts too little, this is a drawback of this header, reel should retract at least 10-15cm more reel revolutions: faster-slower hydraulic flow through the hydromotor in/out the unloading auger , pressing twice - retract by itself and here we have joystick control ... on the keyboard (screen / panel)
you can see here ... I choose everything but I never use it, because I prefer the touch panel, here we have the main switch of the threshing unit, i.e. the whole threshing machine when the table header/auger is clogged - reversing, this is the roof or tank auger - raising and lowering the roof in ... aauger ... in the tank
four-wheel drive, activation, main handbrake, the tank is almost full, and just look at one run and a full tank autolevel (self-leveling) and the engine speed on the potentiometer and here I have control of the chaff spreader what else here we have lights and all other electrical units here I have a spirit level for the autolevel and I activate a lot of components here from the panel/terminal from the panel, you have to give a moment for the straw, just here I will go quietly through this path tec technology which is here, there is a rotary pin in the middle that is responsible for the autolevel header, if you drive too quickly through such furrows and broken technological paths, it will break here, for sure someone of you has already seen it with your eyes, I have three cameras at the back of the sieve there is Mexico on the sieves:] The Matrix will not even match it, and here I have a hook, when I drive up the trailer header, hook it, but there is also Mexico now because everything from the sieves comes out I can also have two I always have the back, straw because you can see 12.1 tons from the back the record was a record ... 12.2 was a new record, 12.1 12.1-12.2 was 12.3? because I did not see (note: yes, it was 12.3;)) there will be a record soon, I think it is dense but the header I try to catch to the end so that it shows the maximum performance per hectare and it is not long, just a few months control is turned on nicely standing wheat 10 (t / ha) shows only now, but 10 to have efficiency, it's also great , we have already harvested almost the entire field is gives well, the world championship finals are still going the hare hare wild strawberry "System Error" the average for us will be 10.4 tons
technological paths occupy I guess I said 6% of the crop well, and if not, correct me, such as the liquid manure is transported in a tanker and all these wide tires make up 6% of the total crop , so you can say that even a lot you have to spray, the fertilizers with drones and sow fertilizers, you need to close the tank closes autolevel has to go back to transport position (zero) okay, it is about to lower I change to a 3rd gear there 3rd the end for today martinflashgordon subscribe to my channel
2021-09-30